LED Lights

The front panel LED indicators are shown below and explained in the following table.This information can be used to check the status of the device and its connections.

Basic Troubleshooting

Power Cycle

Modem: Power cycling the modem or pulling the power and letting it sit for 30 seconds before plugging it back in, accomplishes several things.  It resets the connection to the network and forces the connection to be re-established.  It also causes the electronics and software in the modem to reload.

Personal Devices:   Just as a modem has hardware and software that needs reset from time to time, your personal devices such as computers, tablets, smartphones, etc., all can benefit from being shut down completely and started back up, so the software loads fresh.

Verify cords are all securely connected

Phone:  Pull the cord out of the modem and jack, then re-seat it back in the modem and wall jack to ensure you have a good connection.  Swapping cable ends is a good practice.

Power: Verify that it is plugged in to a working outlet, has a tight connection both to the wall receptacle and to the modem Power jack.

Ethernet: Disconnect from the modem/router and device. Re-seat connections, this is a good time to swap ends of the cable.

 Filtering

Modem: needs to be unfiltered or using a filter splitter if the jack is shared with a telephone.

Phones: All phones need a filter.  Filters are available from the InterBel Business Office.  Install filters directly to the wall jack with the line cord coming out of the filter.

Other Devices:  Any device that connects to your phone line up to and including fax machines, alarm systems, etc., require a filter.   

Note: Filtering can be done at the outside NID, where your service comes into your home.  When this is the case, our technicians will inform you that filters are no longer needed or if they are only needed in specific locations.

 DSL Light

Blinking:  The modem is not connecting back to the network.  Most common causes of this are wiring issues, filtering issues or device failure.

Solid: Indicates the modem has a connection back to the InterBel network.

Connecting my modem

The process to connect your modem is fairly simple.  Use the diagram below to see how your modem will connect to the InterBel Network and your device.

Configuration and Setup Guides

Configuration and Setup Guides

Back to TechCorner

InterBel Telephone Cooperative Inc.
300 Dewey Ave. Eureka, MT 59917
Office: (406) 889-3311 Support: (406) 889-1500
Copyright All Rights Reserved © 2019